This two part 100% solids epoxy resin provides an extremely hard wearing coating with a totally impervious gloss finish.
Its pure epoxy formulation withstands light forklift traffic, oil, chemicals and jet washing.
Coverage: 20sq.m at 200 microns thickness
Supplied in 5kg units.
Pot life: 25 mins @ 20oC Application temperature: 10oC - 25oC To accept pedestrian traffic: 24 hours To accept light wheeled traffic: 4 days Overcoat (if required) time: 16-36 hours Full strength cure time: 7 days Full compressive strength: 68N/mm2 Full tensile strength: 45N/mm2 Full flexural strength: 85N/mm2 Elastic modulus: 2.8KN/mm2 Number of parts supplied: 2 Coverage: Approx. 20 sq.m. per 5kgs unit Primer required: Yes
Please consult the technical data sheet for full technical product data.Flortex EP Safety Data Sheet Size: (166.06 KB) Flortex EP Technical Data Sheet Size: (279.99 KB)
Thorough substrate preparation is essential.
Recommended methods are:
Powerfloated concrete – use a Vacuum Assisted Shotblaster to remove weak laitence and provide a surface key for the coating. If this is not possible, chemically etch with Polycote Etch IT then rinse thoroughly and allow to dry.
Loose paint or rust – remove, using a Vacuum Assisted Shotblaster, Floor Grinder or equivalent method.
Loose or friable concrete – use a Vacuum Assisted Shotblaster. If this is not possible, chemically clean with Polycoate Etch IT then rinse thoroughly and allow to dry.
Oil or grease – use Hot Compressed Air for large areas of contamination. Smaller, isolated deposits may be chemically cleaned with Polycote Degrease IT, then rinsed thoroughly and allowed to dry.
Prior to application of Flortex EP, a suitable primer should be applied. These include Polycote EP Primer, WD Primer or OT Primer, depending on the type and condition of the surface.
Please contact Polycote Technical Helpline, and prepare the surface in accordance with the appropriate primer data sheet.
Having fully prepared the substrate, stir the individual components before mixing together. Add Part 'B' to Part 'A' and thoroughly mix for at least 3 minutes. For best results use a heavy duty slow speed drill with a mixing paddle.
Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation.
Apply by brush, roller or squeegee, making sure that the surface is completely covered.
Particular attention should be given to doorways and other areas of high traffic. When finished, DO NOT scrape the remaining contents from the container as this will invariably include unmixed resin.
Product QuestionsNo questions yet. Be the first to ask the question!