When sealing a crack or gap against escaping water, there's nothing so astoundingly effective as Aquaplug. This highly specialised cementitious powder mix is simply mixed with a small amount of water and forced into the repair area by trowel or gloved hand. Within just 3 minutes it's cured and the flow is permanently stopped!
Aquaplug is a ready to use extremely fast-setting cement based mix incorporating chemical modifiers and selected graded aggregates. Simply mixed with water, the shrinkage compensated mix ensures total fill of the applied area for instant and permanent stemming of water flow.
- Stops leaks in only 3 minutes!!
- Primarily designed for use with concrete.
- Aquaplug will also adhere to brick and blockwork.
Sealing of basements, concrete pipes, sewage systems and foundations. Also used for creating corner fillets prior to tanking with Polycote Aquatex / Aquaguard.
Unit size: 10kg – makes 5.5 litres when mixed
Pot life: 2 - 5 mins @ 20oC Application temperature: 5oC to 35oC Number of parts supplied: 2 Priming required: No
Please consult the technical data sheet for full technical product data.Technical Data Sheet Aquaplug Technisches Datenblatt Size: (73.11 KB) Aquaplug Safety Data Sheet Size: (61.92 KB) Aquaplug Technical Data Sheet Size: (305.08 KB)
Ensure contact surfaces are sound, clean and provide a good mechanical key.
Remove all loose material, plaster and paint.
Oily deposits should be treated with Polycote Degrease IT – see relevant data sheet.
Cracks should be cut back to a minimum of 20mm depth and width, undercutting if possible.
If concrete surfaces are dry, dampen with water immediately before application of Aquaplug to assist adhesion.
Do not mix more than can be applied in 2 minutes.
Mix approximately 4 parts powder by volume to 1 part water.
Consistency of the mix depends on application – semi-wet mix for damp cracks or fillets, put a stiffer mix in when placing against active water. The water content should be adjusted accordingly.
Mixing should be carried out using a gloved hand.
Place the mixed material in place IMMEDIATELY, pressing firmly into the crack or fillet using a fillet trowel.
When working against water pressure work toward the point of highest pressure and finish with a gloved hand, forcing the material against the pressure and holding there until set. Cut off excess material from face within 3 minutes.
Dampen repair surface after application.
Product QuestionsNo questions yet. Be the first to ask the question!
Other Products You May Need
£8.95High quality 7 inch trowel
£18.90For thorough and effective mixing of two-part products.
Excellent for filling of fine cracks, holes and surface imperfections. Very strong, cures in only 20 minutes and can be sanded / painted straight away.
A cement based, waterproof, self levelling compound wall coating – withstands equivalent of 5m head of negative water pressure.