- Details
-
Details
Epoxy primer for areas with no Damp Proof Membrane or rising damp.
Use on: Old or new concrete, with a moisture content of up to 60% and 100% humidity Use where: Internal/External Typical industries: Commercial and industrial premises with rising damp issues Type of job: Preparation of a surface where the damp-proof membrane is either non existent or defective, or on newly poured concrete which hasn't fully dried out yet
Approximate coverage: 5kg - 15-20m2 at 200 microns thick Special features: Forms a tenacious waterproof barrier, can be applied to damp or wet surfaces, heavy duty - Specifications
-
Specification
Pot life: 15 mins @ 20oC or 10 mins on wet surfaces Application temperature: 10oC - 25 oC Cure time: Approximately 24 hours Number of parts supplied: 2 Priming for: Polycote Flortex product range DPM Primer Safety Data Sheet Size: (164.82 KB)
DPM Primer Technical Data Sheet Size: (245.24 KB)
- Application
-
Application
Preparation:
Thorough substrate preparation is essential.
The surface must be free of brittle particles and laitence. Any remains of previous coatings should be removed by means of scabbling, shotblasting and/or diamond grinding.
Important: Free pores must be exposed to ensure good adhesion to the surface.
All water must be removed from the surface, leaving it damp but not wet. DPM Primer may then be applied to the damp surface immediately after cleaning.
Mixing:
Mix part ‘A’ to part ‘B’ in a suitable container, and thoroughly mix for at least 3 minutes. For best results use a slow speed drill with a mixing paddle, making sure all material from the sides and bottom of the container are thoroughly mixed in.
Thorough mixing is imperative as an unmixed product will result in a poor or non-cure situation.
Application:
Apply by brush, roller, or squeegee, in one or more continuous applications until the material is absorbed and a film has formed. Make certain that the entire surface is completely covered to prevent water migration.
If the DPM Primer is being used underneath a screed or self level we advise that you apply one coat of DPM Primer to the surface and allow to cure and then apply a second coat with kiln dried sand broadcast into the wet coating to create a key for the screed or self level to adhere to.
Under no circumstances should aggregate be added to the first coat as this will allow water to bleed through the primer and contaminate the following coats. Relative Humidity Required Reading % Coating Thickness 75-85 1 coat of DPM Primer at 200 microns 85-92 2 coats of DPM Primer at 200 microns per coat 92-97 3 coats of DPM Primer at 200 microns per coat. - Q&A
-
Product Questions
No questions yet. Be the first to ask the question!