Flortex SG is a cost effective, self-priming two part water-dispersed epoxy floor coating with a high solid content. Its formulation includes quality fillers for good abrasion and chemical resistance.
Use on: Old and new concrete, stone, timber Use where: Internal Typical industries: Factories, warehouses, workshops, processing plants, showrooms, retail outlets, veterinary surgeries, hospitals and schools
Approximate coverage: 5 kg unit - 30m2 Overcoating time: 8 - 24 hrs. Curing time: Light traffic 24 hrs. Full Cure - 7 days Special features: Medium duty, solvent-free, easy to clean impervious surface, chemical resistant, impact resistant, abrasion resistant, lasts longer than ordinary paint
You may be interested in our 'Bargain Basement' version of this product.
Pot life: Approx. 60 mins @ 20oC Application temperature: 10oC - 25oC Number of parts supplied: 2 Priming required: No Coats required: 2
Please consult the technical data sheet for full technical product data.Flortex SG Safety Data Sheet Size: (158.06 KB) Flortex SG Technical Data Sheet Size: (266.71 KB) Flortex SG Technisches Datenblatt Size: (142.97 KB)
Thorough substrate preparation is essential.
Recommended methods are: Powerfloated concrete – use a Vacuum Assisted Shotblaster to remove weak laitence and provide a surface key for the coating. If this is not possible, chemically etch with Polycote Etch IT then rinse thoroughly and allow to dry.
Loose paint or rust – remove, using a Vacuum Assisted Shotblaster, Floor Grinder or equivalent method.
Oil or grease – use Hot Compressed Air for large areas of contamination. Smaller, isolated deposits may be chemically cleaned with Polycote Degrease IT, then rinsed thoroughly and allowed to dry.
Timber – remove any loose paint and abrade thoroughly. Ensure surface is clean and free of dust, oil and grease. See relevant Data Sheet prior to application.
Once prepared, the area must be kept clean and free of traffic.
Having fully prepared the substrate, stir the individual components before mixing together. Add Part 'B' to Part 'A' and thoroughly mix for at least 3 minutes. For best results use a heavy duty slow speed drill with a mixing paddle.
Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation.
Apply by brush or roller, making sure that the surface is completely covered. Particular attention should be given to doorways and other areas of high traffic. When finished DO NOT scrape the remaining contents from the container as this will invariably contain unmixed raw resin.
A second coat of Flortex SG should be applied after initial curing has taken place – approximately 16-24 hours.
Product QuestionsNo questions yet. Be the first to ask the question!