Cretex EP is an incredibly strong epoxy resin concrete floor repair. Holds an ability to withstand virtually any traffic with an easy application on cracked or damaged concrete floors. A twin pack solvent-free resin, Cretex EP achieves the highest adhesion and wear resistance.
Use on: Concrete. For other substances contact Polycote Experts. Use where: Internal/External Typical industries: All industries, including food-processing and working environments. Type of job: Almost any floor repair, due to its incredible strength: Broken steps edges, Spalled/pitted concrete, Raising levels, Impact damage, Bolt holes, creating ramped edges for wheeled traffic, Expansion joint edges
Special features: Heavy duty, chemical resistant, impact resistant, abrasion resistant, can be feather edged, fast curing; cost effective – 1:1 mix means NO waste, non-toxic, non-taint, solvent free, compressive strength many times that of concrete
Pot life: 20 mins @ 20oC Application temperature: 10oC - 20oC Depth of repair (1 layer): Feather edge - 100mm Mixing ratio: 1:1 Initial cure time: 6 - 8 hours Full strength cure time: 7 days Full compressive strength: 70N/mm2 Full tensile strength: 20N/mm2 Full flexural strength: 20N/mm2 Number of parts supplied: 2 Coverage: 10kg unit - 1.8m2 @ 3mm Priming required: No
Please consult the technical data sheet for full technical product data.Cretex EP Safety Data Sheet Size: (177.61 KB) Cretex EP Technical Data Sheet Size: (395.36 KB) Cretex EP - Technisches Datenblatt Size: (252.28 KB)
Thorough substrate preparation is essential.
Remove all loose material – wire brushing is advisable. Sweep clean or vacuum.
The surface must be free from grease, oil or contamination. A gas torch will help to remove oil from the surface. If this is not practical, Polycote Degrease IT may be used to clean the area but this must be thoroughly rinsed off and the substrate dried, before applying Cretex EP.
Important: Thoroughly stir both parts individually before mixing ensuring the resin is evenly dispersed, making sure you get right to the bottom of the container.
Having fully prepared the substrate, simply mix the parts A and B together at a ratio of 1:1 to the quantity required, whether it be a complete unit, or a spoonful for a small repair.
Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation.
Keep all components at room temperature 24 hours before use.
Apply by trowel, or by hand for small isolated areas, wearing suitable protective gloves.
Being resin-rich, Cretex EP has a typically sticky consistency and smoothing may be assisted by wetting the trowel using Polycote Solvent Cleaner as a release agent.
For vertical repairs – where step nosings or expansion joint edges have broken away, the vertical face of the repair material should be supported to prevent slumping.
Suitable sized wooden shuttering should be covered with polythene to reduce adhesion, and should be removed as soon as the material is firm.
- Very Impressed, Looks Great
I ordered some of your cretex ep to repair the edges of some old concrete steps. You recommended the above product with a choice of colours to mach the step and I have to say I was and am, very impressed. It was very easy to use. Has set extremely hard and looks great.
I will definitely be recommending your products and be using you again.