Flortex Chemical Coat is a solvent-free epoxy incorporating quality chemical-resistant fillers.
Its totally impervious gloss finish is extremely hard wearing and resists heavy forklift traffic, jet washing and all chemicals.
Flortex Chemical Coat Coverage: approx. 20 sq.m
Supplied in 5kg units (smooth) or 7kg (slip resistant)
Pot life: 20-30 mins @ 20oC Application temperature: 10oC - 25oC Initial cure time: 8-12 hours To accept traffic: 24 hours Overcoat (if required) time: within 36 hours Full strength cure time: 7 days Full compressive strength: 68N/mm2 Full tensile strength: 45N/mm2 Full flexural strength: 85N/mm2 Elastic modulus: 2.8KN/mm2 Number of parts supplied: 2 Coverage: Approx. 20 sq.m. per 5kgs unit Primer required: Yes
Please consult the technical data sheet for full technical product data.Flortex Chemical Coat Technical Data Sheet Size: (293.8 KB) Flortex Chemical Coat Safety Data Sheet Size: (157.11 KB) Flortex Chmie-Coat Technisches Datenblatt Size: (196.9 KB)
Thorough substrate preparation is essential.
Prior to application of Flortex® Chemical Coat, the surface should be primed with Polycote EP Primer or WD Primer, depending on the type of substrate. Please contact Polycote Technical Helpline and prepare the surface in accordance with the appropriate primer Data Sheet.
Should the time lapse between priming and top coat exceed 48 hours, abrade the primer to ensure intercoat adhesion.
Having fully prepared the substrate, stir the individual components before mixing together. Add Part 'B' to Part 'A' and thoroughly mix for at least 3 minutes. For best results use a heavy duty slow speed drill with a mixing paddle.
Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation.
Apply by brush, roller or squeegee, making sure that the surface is completely covered. Particular attention should be given to doorways and other areas of high traffic. When finished, DO NOT scrape the remaining contents from the container as this will invariably include unmixed resin.
Two coats are recommended in areas of high chemical aggression.
The ambient temperature of the areas should not fall below 10oC throughout the application and curing period.
Product QuestionsNo questions yet. Be the first to ask the question!
Other Products You May Need
For applying floor & roof coatings and solvents.
High quality easy to use and long lasting roller kits
£18.90For thorough and effective mixing of two-part products.
EP Primer CR is a 100% solids high build epoxy formulation primer with excellent chemical resistance, suitable for use with a wide range of topcoats and screeds.