If you need a completely clear, non-yellowing UV resistant coating, Flortex Fastset Clear is the answer.
This is a 100% solids twin pack high build clear coating, that is not only incredibly tough, but will ensure a light-stable protective seal to your surface. Flortex Fastset Clear has superb flexibility, making it the ideal choice for timber floors and structures.
Coverage: 5L – 20-25m2
Flortex Fastset Clear is the ideal choice for timber floors, walls, hand rails, steps, stairs, ramps, decking and furnishings.
Pot life: 20-30 mins @ 20oC Application temperature: 2oC - 30oC Initial curing time: 1 - 3 hours Fully cured time: 7 days Recoat time: 3 - 4 hours Number of parts supplied: 2 Priming required: No - however we recommend two coats
Please consult the technical data sheet for full technical product data.
Thorough substrate preparation is essential.
The substrate must be clean, sound, dry and all surface laitenance removed, either by shot blasting, mechanical abrasion or with Polycote Etch It.
The substrate moisture content should be less than 75% ERH on the basis of hygrometer readings.
On concrete surfaces, care must be taken to ensure the surface preparation does not disfigure the surface as this will show through the clear coating.
Wooden substrates should be thoroughly cleaned and any previous coatings and waxes removed from the surface. If necessary sand the surface in the direction of the timber grain.
Flortex Fastset Clear is not recommended to be applied on damp concrete under any circumstances.
Thoroughly agitate Parts 'A' and 'B' individually to disperse any settlement, then add hardener Part 'B' to resin Part 'A' and mix for at least two minutes using a heavy-duty slow speed drill with a mixing paddle.
Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation.
Once mixed, the Flortex Fastset Clear must be applied immediately.
Apply by brush or roller, maintaining an even application.
The ambient temperature must remain above 5oC during the application.
Product QuestionsNo questions yet. Be the first to ask the question!