- Details
-
Details
Typical Uses:
Ideal for application of lines and hatching to most industrial floors including concrete, sand and cement screeds and epoxy coatings. Applications include warehouses, factories, airports, loading/parking bays, numerals and colour coding.
Supplied in 2.5kg units.
Clearance
4 x 2.5kg units in Yellow – 50% OFF - Specifications
-
Specification
Number of parts: 2 Application Temperature: Not below 10oC Pot Life (at 20oC): Approximately 15 minutes Curing Time (at 20oC): Light traffic 8-10 hours Coverage: 62 lin. metres at 100mm wide at a thickness of 240 microns Please consult the technical data sheet for full technical product data.
Flortex Linemarker Technical Datasheet Size: (268.74 KB)
Flortex Linemarker Safety Datasheet Size: (189.9 KB)
- Application
-
Application
Preparation:
Ensure the surface is clean and dry, and that all loose and friable material has been removed. Any oil or grease must be removed using Polycote Degrease IT prior to application of Flortex Linemarker.
Mixing:
Pre-mix the coloured base component to a uniform consistency then mix the entire contents of the base with the hardener. Mix using a slow speed electric mixer for approximately two minutes or until the two components have fully combined.
Application:
Measure and mark out the position of all lines to be painted. Long straight edges may be marked with accuracy by snapping a chalk line. Masking tape may be used to achieve clean edges, or a length of angle or plywood may be used as a straight edge.
Apply the mixed Flortex Linemarker using a paintbrush of the same width as the line to be applied. If using a roller, spread the material rapidly and then roll to finish. Remove tapes shortly after application by pulling across the line.
Ensure that rollers are changed regularly to prevent cure of material in the roller. - Q&A
-
Product Questions
No questions yet. Be the first to ask the question!