Flortex EPS is a self-priming solvent based epoxy resin with a hard-wearing and totally impervious surface offering excellent chemical resistance and abrasion
Use on: Metal, concrete, timber Use where: Internal Typical industries: Engineering plants, chemical plants, food factories, breweries Type of job: Ideal for floors, ramps, metal stairs, fire escapes and platforms, gantries, machinery, tanks, railings, pipework and ducting Approximate coverage: 5 kg unit - 30m2 Special features: Heavy duty, long pot life allows for intricate work or several coats in one mix, chemical resistant, impact resistant, abrasion resistant
Pot life: 18 hours @ 20oC Application temperature: 10oC - 30oC Cure time: Re-coat - 4 hours @ 20oC Initial Cure - 2 - 4 hours Full Cure - 7 days Number of parts supplied: 2 Priming required: Prime metal surfaces with Polycote EPS Primer
Please consult the technical data sheet for full technical product data.Flortex EPS Technical Data Sheet Size: (349.1 KB) Flortex EPS Safety Data Sheet Size: (186.92 KB)
Flortex EPS should only be applied to a well prepared, abraded (by shotblasting or similar), clean, dry surface, free of oil and grease.
If applying Flortex EPS to a metal surface, this will need priming first with EPS Primer.
Having fully prepared the substrate, stir the individual components before mixing together. Add part 'B' to part 'A' and thoroughly mix for at least 3 minutes. For best results use a heavy duty slow speed drill with a mixing paddle.
Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation.
Apply by brush, roller or airless spray, making sure that the surface is completely covered.
Particular attention should be given to protrusions and other areas of high potential wear. When finished, DO NOT scrape the remaining contents from the container as this will invariably include unmixed raw resin.
Product QuestionsNo questions yet. Be the first to ask the question!