Flortex Fastset Clear

Flortex Fastset Clear
An ultra tough, clear, UV resistant polyurethane floor sealer.
  • Hard wearing and abrasion resistant
  • Waterproof and chemical resistant
  • UV resistant and non-yellowing
  • Ready for use in 1-3 hours depending upon temperature

Quantity Calculator

Flortex Fastset Clear
5 litres

£187.90
  • Buy 5 for £184.50 each
  • Buy 10 for £181.60 each
  • Buy 25 for £179.50 each
  • Buy 50 for £178.40 each

You may also need

Price for all selected : £0.00
  1.    This itemFlortex Fastset Clear

Request Quote
Or call: 0800 980 0852 / 01234 846400

Details

Details

If you need a completely clear, non-yellowing UV resistant coating, Flortex Fastset Clear is the answer.

This is a 100% solids twin pack high build clear coating, that is not only incredibly tough, but will ensure a light-stable protective seal to your surface. Flortex Fastset Clear has superb flexibility, making it the ideal choice for timber floors and structures.

Coverage: 5L – 20-25m2

Typical Uses:
Flortex Fastset Clear is the ideal choice for timber floors, walls, hand rails, steps, stairs, ramps, decking and furnishings.

Specifications

Specification

Pot life:20-30 mins @ 20oC
Application temperature:2oC - 30oC
Initial curing time:1 - 3 hours
Fully cured time:7 days
Recoat time:3 - 4 hours
Number of parts supplied:2
Priming required:No - however we recommend two coats

Please consult the technical data sheet for full technical product data.

View FileFlortex Fastset Clear Safety Data Sheet    Size: (145.39 KB) View FileFlortex Fastset Clear Technical Data Sheet    Size: (390.74 KB)
Application

Application

Preparation:
Thorough substrate preparation is essential.
The substrate must be clean, sound, dry and all surface laitenance removed, either by shot blasting, mechanical abrasion or with Polycote Etch It.
The substrate moisture content should be less than 75% ERH on the basis of hygrometer readings.
On concrete surfaces, care must be taken to ensure the surface preparation does not disfigure the surface as this will show through the clear coating.
Wooden substrates should be thoroughly cleaned and any previous coatings and waxes removed from the surface. If necessary sand the surface in the direction of the timber grain.
Flortex Fastset Clear is not recommended to be applied on damp concrete under any circumstances.


Mixing:
Thoroughly agitate Parts 'A' and 'B' individually to disperse any settlement, then add hardener Part 'B' to resin Part 'A' and mix for at least two minutes using a heavy-duty slow speed drill with a mixing paddle.
Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation.


Application:
Once mixed, the Flortex Fastset Clear must be applied immediately.
Apply by brush or roller, maintaining an even application.
The ambient temperature must remain above 5oC during the application.

Q&A

Product Questions

No questions yet. Be the first to ask the question!

Customer Reviews

Login, and be the first to review this product

Add a Review

Other Products You May Need

Please wait...

Product Successfully Added to Your Cart