Flortex UVR

Flortex UVR
An ultra tough, clear, UV resistant polyurethane floor sealer.
  • Waterproof and chemical resistant
  • UV resistant and non-yellowing
  • Superb flexibility
  • Incredibly tough
  • Tack free in 6-8 hrs
  • Full cure in approx. 24 hrs

Quantity Calculator

Flortex UVR
5 litres

£187.90
  • Buy 5 for £178.50 each
  • Buy 10 for £169.60 each
  • Buy 25 for £162.80 each
  • Buy 50 for £156.40 each

You may also need

Price for all selected : £0.00
  1.    This itemFlortex UVR

Request Quote
Or call: 0800 980 0852 / 01234 846400

Details

Details

If you need a completely clear, non-yellowing UV resistant coating, Flortex UVR is the answer.

This is a 100% solids twin pack high build clear coating, that is not only incredibly tough, but will ensure a light-stable protective seal to your surface. Flortex UVR has superb flexibility, making it the ideal choice for timber floors and structures.

Coverage: 5L – 20-25m2

Typical Uses:

Flortex UVR is the ideal choice for timber floors, walls, hand rails, steps, stairs, ramps, decking and furnishings.

Specifications

Specification

Pot life:20 mins @ 20oC
Application temperature:10oC - 25oC
Initial curing time:8 - 12 hours
Fully cured time:7 days
Recoat time:12 - 24 hours
Number of parts supplied:2
Priming required:No - however we recommend two coats

Please consult the technical data sheet for full technical product data.

Technical Data Sheet View FileFlortex UVR Safety Data Sheet    Size: (143.15 KB)
Application

Application

Preparation:
Thorough substrate preparation is essential.
Recommended methods are:
Powerfloated, loose or friable concrete – use a Vacuum Assisted Shotblaster to remove weak laitance and provide a surface key for the coating. If this is not possible, chemically etch with Polycote Etch IT then rinse thoroughly and allow to dry.
Loose paint or rust – remove, using a Vacuum Assisted Shotblaster, Floor Grinder or equivalent method.
Oil or grease – use Hot Compressed Air for large areas of contamination.
Smaller, isolated deposits may be chemically cleaned with Polycote Degrease IT then rinsed thoroughly and allowed to dry. See relevant Data Sheet prior to application.
Once prepared, the area must be kept clean and free of traffic.


Mixing:
Thoroughly agitate Parts 'A' and 'B' individually to disperse any settlement, then add hardener Part 'B' to resin Part 'A' and mix for at least two minutes using a heavy-duty slow speed drill with a mixing paddle.
Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation.


Application:
Once mixed, the Flortex UVR must be applied immediately.
Apply by brush or roller, maintaining an even application.
The ambient temperature must remain above 10oC and the surface temperature above 5oC during the application.

Q&A

Product Questions

No questions yet. Be the first to ask the question!

Customer Reviews

Login, and be the first to review this product

Add a Review

Other Products You May Need

Please wait...

Product Successfully Added to Your Cart