Formulated from the latest resin technology, PB Floor Paint is incredibly tough and long lasting with good oil and chemical resistance.
Use on: Concrete. For other substances contact Polycote Experts. Use where: Internal Typical industries: Widely used throughout industry. Warehouses, factories, showrooms, workshops, hotels, farms and garages have all proved the superb qualities of PB Floor Paint.
Special features: Tough but flexible, chemical resistant, impact resistant, abrasion resistant, quick and easy to apply, can be applied over previously painted surfaces, fast curing, superb adhesion qualities, very high opacity/solids content
You may be interested in our 'Bargain Basement' version of this product.
Application temperature: 5oC - 30oC Touch dry time: 3 hours @ 20oC Hard dry time: 5 hours Number of parts supplied: 1 Coverage: 5L unit - 30m 2 Priming required: No
Please consult the technical data sheet for full technical product data.PB Floor Paint Technical Datasheet Size: (176.65 KB) PB Floor Paint Safety Data Sheet Size: (131.2 KB) PB Bodenfarbe Size: (193.71 KB)
Thorough substrate preparation is essential.
The surface must be clean, dry and free from dirt, grease and other contamination. New concrete should be left for at least 3 months before painting, and a moisture check should be carried out to ensure this lies within acceptable limits. Hard concrete or granolithic surfaces should be treated with Polycote Etch IT to improve adhesion, and any surface grease or contamination chemically removed using Polycote Degrease IT. These treatments must be thoroughly rinsed off and the surface allowed to dry before painting. Pits and holes may be filled using Polycote Cretex products. Please refer to relevant Data Sheets.
Stir very thoroughly before use to ensure full dispersion of solids throughout the mix. Mechanical mixing is advised.
Apply by roller or brush. If the area has not previously been treated, thin the first coat with 10% White Spirit to improve penetration and adhesion working well into the surface. Apply full second coat. On previously sealed floors apply two coats. On previously painted surfaces one coat may provide adequate coverage.
Avoid applying too thickly.
Do not cover at a rate less than 30m2 per 5L unit. Applying polyurethane paint too thickly can prevent curing.
Product QuestionsI have a garage that I store old vintage cars in. Will this product be okay for sealing the floor?Question by: Tom Newman on 4 Jun 2015 09:26:00Tom,
It would depend on if the cars will be used often or its its solely for storage.
This is classed as a single pack coating where the solvent has to escape through the coating in order to dry. This leaves you a micro-porous finish.
If you are driving hot car tyres onto this coating then as the vehicle is parked and the tyres cool down the plasticiser will travel into the coating and when you move the car this may take the paint with it.
The best options would be a twin-pack epoxy which cures chemically and gives you a impervious finish and will far outlast PB Floor Paint.
Please feel free to contact our technical team for further information.Answer by: Stuart White (Admin) on 4 Jun 2015 09:42:00
Other Products You May Need
For applying floor & roof coatings and solvents.
High quality easy to use and long lasting roller kits
£18.90For thorough and effective mixing of two-part products.
Industrial heavy duty coloured PVC line marking tape – easy to lay with tenacious adhesion.