HyGlaze EP – Clearance

High build pure epoxy wall coating providing an easy clean coloured gloss finish that will not allow mould or fungal growth. Non toxic or taint, solvent free. Normally applied over WD Primer and can be applied up to 400 microns thick. It is extremely hardwearing and is chemical and abrasion resistant.
  • 1 x 1.5kg Unit - White - (return) £25
  • 4 x 2.5kg Units - Yellow - RAL 1003 (overstock) £30 each
  • 1 x 5kg Unit - White £80

HyGlaze EP – Clearance
5 kg

Regular Price: £118.75

Special Price £59.00


Request Quote
Or call: 0800 980 0852 / 01234 846400



Hy-Glaze™ EP is a thixotropic two part epoxy wall coating with a solids content of 97%. Its specialised formulation enables a thickness of up to 0.5mm to be achieved easily in two coats. Extremely tough, totally impervious and highly resistant to chemicals and jet washing, Hy-Glaze™ EP provides an easy clean coloured gloss finish that will not allow mould or fungal growth.

Supplied in 5kg units.

Coverage per unit: 15m2

Typical Uses:

Used extensively throughout industry in hospitals, hotels, farms, zoos and food factories etc., in kitchens, milking parlours, monkey houses etc.



Technical Data Sheet View FileHyGlaze EP Safety Data Sheet    Size: (159.37 KB)


Thorough substrate preparation is essential.
Prior to application of Hy-Glaze™ EP, the surface should be primed with either Polycote WD Primer or Polycote EP Primer, depending on the type and condition of the substrate. Please contact Polycote Technical Helpline for advice, and follow preparation guidelines on the relevant primer Data Sheet.

Having fully prepared the substrate, stir the individual components before mixing together. Add Part 'B' to Part 'A' and thoroughly mix for at least 3 minutes. Keep all components at room temperature for 24 hours before use. For best results use a heavy duty slow speed drill with a mixing paddle.
Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation.

Having prepared and primed the surface, Hy-Glaze™ EP should be applied after the primer has completely dried but within 36 hours of priming to ensure a good intercoat chemical bond. Apply by brush or roller making sure that the surface is completely covered.
Particular attention should be given to any protrusions or other vulnerable areas. When finished, DO NOT scrape the remaining contents from the container as this will invariably include unmixed raw resin.


Product Questions

No questions yet. Be the first to ask the question!

Customer Reviews

Login, and be the first to review this product

Add a Review

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Please wait...

Product Successfully Added to Your Cart