This dual-action metal priming formula is designed to penetrate and stabilise corrosion on ferrous metals.
Forms an effective barrier against water and chloride ions, thereby arresting the corrosion process for long-term protection.
Rustex is a single-pack water-based high performance primer incorporating a rust-inhibiting active constituent and a copolymer latex emulsion.
This dual-action formula is designed firstly to penetrate and stabilise corrosion on ferrous metals, and secondly to form an effective barrier against water and chloride ions, thereby arresting the corrosion process for long-term protection.
Rustex requires minimal preparation, is non-toxic, non-flammable, easy to apply and dries rapidly
Number of parts: 1 Application temperature: 10oC to 30oC Drying time: Touch dry: 30 minutes Recoat: 2 hours Coverage: 1L: 8m2 5L: 40m2 Number of coats: 2
Please consult the technical data sheet for full product technical data.Rustex Technical Data Sheet Size: (385.78 KB) Rustex Safety Data Sheet Size: (115.72 KB)
Rustex is normally used for treatment of rusted steel prior to application of paint or other coating systems.
It is ideal for situations where blast cleaning is not practical or desirable.
Remove all dirt, old paint and loose rust by wire brush, in accordance with St2 standard.
Wash with a water-based detergent solution to remove oil and dust, followed by thorough rinsing with clean water.
The surface may be damp BUT NOT WET when Rustex is applied.
Stir well before use.
Any rust particles picked up on the paintbrush will be liable to contaminate the paint in the container, reducing the shelf life.
This can be avoided by pouring a sufficient amount into a separate plastic container for each operation. DO NOT return unused material to the original container.
Brush application is recommended for the first coat to ensure thorough penetration into the rust.
Other application methods are:
Roller – a short nap roller may be used. Foam rollers are not recommended.
Air assisted spray – thin with up to 10% water. Use a 0.40mm, 40-60o tip and 40-80 psi air pressure.
Airless spray – typically a 28:1 airless spray unit at 70 psi would be used, with 0.25-0.40mm, 40-60o tip and 1400-2100 psi fluid pressure at tip.
Product QuestionsNo questions yet. Be the first to ask the question!
Other Products You May Need
For applying floor & roof coatings and solvents.
£58.70Fungicidal wash solution – ideal to prevent regrowth of algae and similar weeds on roofs, walls, ceilings and masonry.
An instant repair brush-grade flexible roof paint designed for providing roofs with an immediate waterproof coating.