Due to its corrosion resistance properties, Stormtex is ideal for use on exterior structural steelworks, agricultural equipment, marine, etc.
Applied by spray or roller.
Supplied in 5 litre units.
Thorough substrate preparation is essential.
Previous paint should be abraded, or removed if flaking or loose. Exposed metal surfaces should be primed with Stormtex Metal Primer – see relevant Data Sheet for recommended preparation for priming. Stormtex may be applied over the primer 6 hours after priming.
Stir thoroughly before use. If the product is to be applied by spray, Thinners should be thoroughly mixed according to the guidelines following – see 'Application'.
Brush and roller – Stormtex may be thinned with up to 5% Thinners.
Air assisted spray – thin with up to 10% Thinners. Use 1.8mm nozzle and 40-50 psi air pressure. Apply to 80 micron recommended Wet Film Thickness.
Airless spray – thin with maximum 5% Thinners. Use 0.48-0.59mm, 65-80o tip and 2000-2500 psi air pressure. Apply to 80 micron WFT.
Product QuestionsNo questions yet. Be the first to ask the question!
Other Products You May Need
For applying floor & roof coatings and solvents.
£66.90High quality easy to use and long lasting roller kits
£58.70Fungicidal wash solution – ideal to prevent regrowth of algae and similar weeds on roofs, walls, ceilings and masonry.